Tungsten filament IR lamp

Sat, 06 Jun 2026 02:42:47 +0800

Out on the line, glass doesn’t wait. A tempering furnace that’s hesitating, a bending station chasing temperature swings, or a lamination press that can’t hold setpoint—those issues drop yield and pile up scrap. When heat doesn’t perform, you pay in cracked panels, stretched cycles, and wasted energy. Tungsten filament IR lamps give glass plants the kind of heat control that keeps the process honest. What matters, technically These lamps deliver short-wave infrared, with a fast-rise tungsten filament inside a quartz envelope. That translates to millisecond response when you change power, so you can match the thermal profile in tempering, bending, coating drying, and lamination without overshoot. Peak wavelengths land around 0.9–1.2 μm, tuned for strong absorption by glass and metallic coatings, so you spend less time idling. Output stays stable over long runs, and we shape the filament geometry to keep the radiant field even across the target width—fewer hot spots that drive thermal stress and optical distortion. Why it works where it counts In tempering, uniform heat across the sheet keeps bow and roll in check, so the quench hits evenly and optical quality stays solid. In bending, the lamp’s quick response lets you follow complex contours without over-soaking the furnace, which shortens changeovers. For EVA and SGP lamination, rapid, controlled heating helps drive out entrapments and voids, so the bond line integrity improves. In insulating glass sealing and coating lines, that same speed reduces the pull of convection, giving you repeatable drying and curing with less gas or electricity. You end up heating the product, not the room, and cycle times come down without cutting corners on safety. Here is what you need to watch for These lamps are sensitive to voltage and how they’re mounted. Match the ballast and reflector to the lamp’s power and length, and set the focal plane to the glass surface so you actually get the rated intensity. Keep the quartz clean—even a thin film of dust or condensates will skew output and shorten life. Expect shorter service life if you run above rated power or mount them in high-vibration spots near presses. Plan for thermal expansion in the fixture, and double-check electrical clearances before you swap in OEM modules. Installed right, they run long hours with stable output, and the payoff is consistent glass, fewer rejects, and uptime you can count on.

Tungsten on Quartz Infrared Heating Systems

Tungsten filament IR lamp